Commercial Duct Cleaning Process
Our Process of Duct Cleaning
Step 1: Area Inspection and Preparation
A crew of two to four certified technicians will arrive on the job site as scheduled.
Step 2:
Our certified technicians will use commercial grade equipment
Step 3:
To protect the building’s floor, our technicians will layer drop sheets where necessary and cover work terminals.
Step 4:
The building staff should not be in the direct work area when our technicians complete duct cleaning. This maximizes occupant safety and prevents interruptions during the cleaning process.
Step 5:
Our technicians will begin our work from the mechanical room or specified area.
Step 6:
This is what your building’s duct system looks like BEFORE cleaning.
Step 7:
Our technicians locate and cut access points on supply/return lines.
Step 8:
Our commercial graded equipment vacuum is attached to the supply and return lines.
Step 9:
- Air pressure of 300 PSI will be used to clean all diffusers and return grills.
- This will be followed by wiping and disinfecting the fuser.
All main duct lines are cleaned with a semi-robotic brush and bouncing ball which cleans the inner walls of the duct system. This is repeated 2-5 times as necessary to lose and agitate dirt and debris toward the vacuum.
Step 10:
All main duct lines are cleaned with a semi-robotic brush and bouncing ball which cleans the inner walls of the duct system. This is repeated 2-5 times as necessary to lose and agitate dirt and debris toward the vacuum.
Step 11:
- Main lines located in the basement are then cleaned with our retractable snake jet system (with air pressure of 300 PSI).
- This tool will clean the hard to reach places, including the corners within the line and bring all the loose dirt towards the vacuum working as an air-rake.
Step 12:
All one-inch access points are closed by installing black plugs. Eight-inch access holes are covered using stainless sheet metal plate, sealed with aluminium tape.
Step 13:
This is what your building’s duct system looks like AFTER cleaning.
Step 14:
- The work area is cleaned and all equipment is wrapped up.
- The lead technicians review the entire work process with client’s staff.
Step 15:
We will give you a report on our progress to the main business occupant. We appreciate your business and will do what it takes to deliver the best service possible.
